Setting K Value
Hi All,
Trying to improve the print quality on my MK4 with a certain PLA filament, it's a matte filament and it seems to come out a bit rougher, leaving slight blobs when doing a lot of retracting, some other filaments I use it's not so much an issue. Have dried the filament and don't think this is the problem.
Added the MMU3 to my MK4 over the weekend hoping to do bigger multicolour prints (less waste) rather than do so on Bambu A1/P1P's but the print quality I'm getting is notably lower.
On the Bambu's I just do the flow calibration and pick the best line and note down that for the filament as well as slow down a few things in the print speed and I get great quality prints, I'm just not sure how to do the same calibration test on the MK4 in Prucaslicer, I wish they would add all the calibrations from Bambu/Orca Slicer.
Normally on the matte filaments I end up with a 0.035 on the Bambu and wonder whether I can use this value for the MK4 and make an adjustment somewhere.
Have tried printing lower temperature and not much improvement going lower in temperature, any suggestions would be great.