Notifications
Clear all
A problem with the new MK4 profile and digital slicer files.
I've printer a few of these Comic Traffic Cones over the years. Never had a print failure when printing them on my old MK3 or, until recently, on my new MK4. On two of the parts I now get mid print failures. I've included photos. I use Prusa Slicer and your profiles. I did a test, using an off brand printer. I sliced with Prusa Slicer and the files print perfectly.
These print failures appeared after I installed the new MK4 profiles and flashed the printer with stable release 5.1.0.
Opublikowany : 14/12/2023 1:12 pm