resume printing question
I had a stuck piece of filament warning come up during a print. It is still extruding filament but it's a lot thinner than normal.
I changed nozzles to see if that fixed it but I can't find or get back to resume printing.
Is that possible?
RE: resume printing question
Bueller.....Bueller..
RE: resume printing question
Here...
Here...
here? 😁
I read that but it doesn't explain how to get back to resume printing
RE: resume printing question
Sorry, I was enjoying your movie reference and assumed the issue was the 'thinner than normal' extrusion. The cold pull would address that. No idea about resuming a previously halted print.
RE: resume printing question
Sorry, I was enjoying your movie reference and assumed the issue was the 'thinner than normal' extrusion. The cold pull would address that. No idea about resuming a previously halted print.
lol. no worries. I'm starting to think it can't be done. Unfortunately it is a big waste of filament if I have to start over.