Notifiche
Cancella tutti
Mk4 Official Enclosure Filament Guide Question
I am looking through the enclosure instructions for mk3s since they don't have the full mk4 manual out. I can print the different lcd holders without a problem. I am confused however as to how the modified PTFE tube adaptor is supposed to work on the mk4 extruder. Anyone know the answer to this? Thanks!
Postato : 08/06/2023 2:56 pm
RE: Mk4 Official Enclosure Filament Guide Question
A PTFE coupler is part of the hardware included with the enclosure. The MK4 extruder has threads in the filament inlet. Just screw in the coupler and connect the PTFE tube to it.
Postato : 08/06/2023 3:06 pm
Aquaerics hanno apprezzato
Topic starter
answered:
RE: Mk4 Official Enclosure Filament Guide Question
I totally missed the pre threading! Thanks :).
Postato : 09/06/2023 9:10 pm
Aquaerics hanno apprezzato