Just got my MK4 kit
I just got my MK4 kit. Anything I should be aware of before assembling it? I plan to put it in a Creality enclosure and run Octoprint with it.
Senior Life member of IEEE.
RE: Just got my MK4 kit
Hello Steve ( from France 🙂
I can suggest you to take a look to ALL the comments, at each step of each chapter... I discovered this fonctionality when I found the mistake I did at the step 3 of the chapter 5... Have fun...
RE: Just got my MK4 kit
I just did two of the MK3S -> MK4 upgrades. And I agree, read everything a couple times and be slow and deliberate. Give yourself a few days to do it. Do not try to rush through it.
RE: Just got my MK4 kit
Could not agree more
Watch my videos through! - Link in sig 😉 You won't need anything else!
RE: Just got my MK4 kit
The build videos are GREAT. I have watched the entire series once to ensure the build was within my capabilities. I plan on watching them again once my MK4 kit arrives.
RE: Just got my MK4 kit
Watch my videos through! - Link in sig 😉 You won't need anything else!
I appreciated watching your videos while waiting for shipment.
The MK4 was my first 3d printer and I was nervous when I opened the box.
It went smooth and much faster than I anticipated. I did mess up with bearing placement caught during self test. I think it slipped before screws were tightened. Simple fix but had me thinking it was much more of an issue.
Overall, it was easy. Although, I don't care how the wired are ran underneath. The aluminum should have slots cut out or something.