Notifiche
Cancella tutti

Bad printing - No answers from PRUSA SS  

Pagina 2 / 2
  RSS
Alejandro
(@alejandro-3)
Utenti
RE: Bad printing - No answers from PRUSA SS

Interesting...  i will keep that on mind !

Again, thanks for your support !

 

Saludos

 

Postato : 29/07/2024 9:41 pm
chmax
(@chmax)
Eminent Member
RE: Bad printing - No answers from PRUSA SS

If I may add to all excellent "check points" that were listed in the previous posts: 

- screws tightening: in my MK4, after about two weeks of printing (a few parts every 2-3 days, so not much) pretty much all screws need to be tightened again. In some cases up to a quarter turn.

I guess the IS induced vibrations have an effect on the screws, the good thing is that this is a rather quick and easy check.

Postato : 31/07/2024 11:47 am
Pagina 2 / 2
Condividi: