Notifications
Clear all
Stránka 2 / 2
Předchozí
RE: Bad printing - No answers from PRUSA SS
Interesting... i will keep that on mind !
Again, thanks for your support !
Saludos
Napsal : 29/07/2024 9:41 pm
RE: Bad printing - No answers from PRUSA SS
If I may add to all excellent "check points" that were listed in the previous posts:
- screws tightening: in my MK4, after about two weeks of printing (a few parts every 2-3 days, so not much) pretty much all screws need to be tightened again. In some cases up to a quarter turn.
I guess the IS induced vibrations have an effect on the screws, the good thing is that this is a rather quick and easy check.
Napsal : 31/07/2024 11:47 am
Stránka 2 / 2
Předchozí