Notifiche
Cancella tutti
Pagina 5 / 5
Precedente
RE: Y-axis self test failing consistently
Just discovered the same problem, y-axis calibration failures with no obvious cause. I built my MK4 about 14 months ago, haven't had much need for re-calibrating once it was up and running. Just upgraded to MK4S, and it began failing on the y-axis calibration tests. Read these posts. Checked my y-axis bearings. Sure enough, the front left bearing had crept backwards a bit. Loosened its screws, nudged it into position, re-tightened the screws. Re-ran the calibration and its right as rain.
Postato : 24/12/2024 4:04 am
ssmith hanno apprezzato
RE: Y-axis self test failing consistently
Same issue here. Zip-tie method did the trick!
Postato : 25/12/2024 10:09 pm
Pagina 5 / 5
Precedente