Bearings not smooth?
Have greased bearing etc well, and orientated them correctly as marked. However when moving the x-carriage back and forth they do not seem smooth, and seems loud?
Is this normal and just me, or something wrong here??
https://www.youtube.com/shorts/QVZBWkTgjaM
--> MK4 - MK4S - MINI+ - Accelerometer Guide - BambuLab A1 Combo <--
RE: Bearings not smooth?
FYI - Prusa Chat were very helpful. Send the video across and this was the response:
”It sounds fine - it will always be much louder when you move it by hand compared to when it's controlled by the board. If anything, you can loosen your X belt just a tad. But overall I don't hear anything concerning in the video”
He even sent me a video of his own printer at home to confirm the sound!! Can’t ask for much more then that!
--> MK4 - MK4S - MINI+ - Accelerometer Guide - BambuLab A1 Combo <--
RE: Bearings not smooth?
You are going to be shocked at how quiet this thing is.
--------------------
Chuck H
3D Printer Review Blog
RE: Bearings not smooth?
Hope so! Lol
You are going to be shocked at how quiet this thing is.
--> MK4 - MK4S - MINI+ - Accelerometer Guide - BambuLab A1 Combo <--
RE: Bearings not smooth?
Many year MK3 owner with a 3 day old MK4. I’ve run into the room several times thinking the MK4 was dead/broken, only to find it’s just quieter.
of course, I had the original power supply and replaced it with a 240W meanwell (with fan) when PRUSA was still insisting that the original (120W?) power supply was specked sufficiently.
When someone asks you if you're a god, you say, "YES!"
RE: Bearings not smooth?
You were right - its certainly quieter!!!
You are going to be shocked at how quiet this thing is.
--> MK4 - MK4S - MINI+ - Accelerometer Guide - BambuLab A1 Combo <--