Notifications
Clear all
Printer ejects filament after print ...Where to stop that and how to correct
Printer ejects filament after print ...Where to stop that and how to correct
Posted : 06/03/2025 8:54 pm
RE: Printer ejects filament after print ...Where to stop that and how to correct
My first look would be at the printer profile to make sure it's default and doesn't contain modified end gcode.
Formerly known on this forum as @fuchsr -- https://foxrun3d.com/
Posted : 06/03/2025 10:01 pm
1 people liked
Topic starter
answered:
RE: Printer ejects filament after print ...Where to stop that and how to correct
Yes I was on the wrong printer
got the .5+ and not just +
Downloaded the correct firmware to flash but I think it kept some old settings.
Prusa has since cleared up some of my Mac issues . Stopped eject the fillament but still get machine and firmware error.
I have 3.14.1-8237
Slicer 2.9.1
have flashed multiple times
and will again I guess …Living the life
Tanks for your answer.
Posted : 13/03/2025 1:27 pm