Avisos
Vaciar todo
Z-calibration
Is there a gcode-file available somewhere for the Z-axis-calibration-routine used by the MK3?
I would really like to use this same procedure for my other older printer, so that I can compare results and tune it properly.
thx!
Respondido : 26/04/2018 10:25 pm
Re: Z-calibration
Hi Ludo,
It used to be called V2 Calibration
and is available in the right hand column on this page >>> https://www.prusa3d.com/drivers/
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Respondido : 26/04/2018 10:51 pm