What is your favourite black matte filament?
 
Notifications
Clear all

What is your favourite black matte filament?  

  RSS
AR
 AR
(@ar)
New Member
What is your favourite black matte filament?

Hi everyone,

I’m looking for a black matte filament for quality prints.

I’ve tried „das filament“ but wasn’t happy with the print quality. „extrudr“ worked better for now.

Do have any experiences/recommendations?

thanks, Rupert

Posted : 24/01/2022 12:56 pm
fortinmike
(@fortinmike)
Estimable Member
RE: What is your favourite black matte filament?

Don't know if this is the finish you're looking for, but I think PolyTerra PLA looks great. It's not too costly either. Here is something I printed with it: https://www.prusaprinters.org/prints/10349-raspberry-pi-3b-sleeve/comments#comment-92557

Posted : 24/01/2022 2:54 pm
Diem
 Diem
(@diem)
Noble Member

Why not paint it?

Cheerio,

Posted : 24/01/2022 3:15 pm
AR
 AR
(@ar)
New Member
Topic starter answered:
RE: What is your favourite black matte filament?

Looks good.

What printer is it?

Rupert

Posted : 24/01/2022 5:49 pm
AR
 AR
(@ar)
New Member
Topic starter answered:
RE: What is your favourite black matte filament?

I'm trying to keep the worflow as short as possible.

Posted : 24/01/2022 5:50 pm
fortinmike
(@fortinmike)
Estimable Member
RE: What is your favourite black matte filament?

Printed with the Prusa MINI+

Posted : 24/01/2022 6:00 pm
AndersK
(@andersk)
Eminent Member
RE: What is your favourite black matte filament?

AddNotth AduraX, Beautiful finish and really good properties for functional parts.

It's carbon fiber filled nylon.

Unfortunately I can't show any of the prints I've done but there's some examples on their website

Posted : 28/01/2022 10:01 am
Thyraz
(@thyraz)
Active Member
RE:

I also like Polyterra in all it's colors, but haven't used black so far.
My matte black is Tinmorry Matte Black PLA.

You can see a print where I used it here:
comments
Edit: seems like I can't link directly to my make, so scroll down until you see the make posted by Thyraz (me).

The flaps aren't post processed, I just used ironing in Prusa Slicer.
Based on my tests with Polyterra in other colors I guess i would behave similar, 
but at least the Tinmorry is a very easy to use PLA for me with good results.

Posted : 28/01/2022 3:00 pm
Share: