Vase Mode
What is the advantage of Vase Mode? I have made a number of vases and never used it (did not know it was available) but what am I missing by not putting it in "Vase Mode"?
RE: Vase Mode
In Vase Mode the print is continuous from start to finish, so there are no seams.
Formerly known on this forum as @fuchsr -- https://foxrun3d.com/
RE: Vase Mode
Also, see https://help.prusa3d.com/article/layers-and-perimeters_1748
Of course, the forum software wouldn't let me update my previous post...
Formerly known on this forum as @fuchsr -- https://foxrun3d.com/
RE: Vase Mode
Thanks for the reply! Now that IS of interest and something I will try. When you select the Vase Mode it asks to make other changes as well. When you unselect it does it replace the changed setting back?
RE: Vase Mode
Thanks for the reply! Now that IS of interest and something I will try. When you select the Vase Mode it asks to make other changes as well. When you unselect it does it replace the changed setting back?
RE: Vase Mode
It should. But then again, I really don't have use for vase mode myself so I'm not sure, haven't used it enough to remember.
Formerly known on this forum as @fuchsr -- https://foxrun3d.com/