Benachrichtigungen
Alles löschen

Tree support broke mid-print  

  RSS
Craftsman_Chris
(@craftsman_chris)
Active Member
Tree support broke mid-print

Hello. I was printing Bellatrix's wand with tree supports for about 3 hours.The support broke mid-print.

What could be the reason for this?

I am using Prusa slicer, 0.2mm layer height, PLA+,200°,60°. Ender 3 S1 pro

I was printing a similar wand a couple of days ago and I did not have any issues. I have not changed anything on the settings besides the flow rate.

https://ibb.co/QdmfpvS

https://ibb.co/M8LJM1R

https://ibb.co/wLGQMsg

https://ibb.co/Ttj2BgF

https://ibb.co/6RrxWkX

Here is the video.

https://www.tiktok.com/@craftsman_chris/video/7341005200100019489?_r=1&_t=8kHtazuH1of

 

I am not sure if this is the correct topic for this question.

Veröffentlicht : 29/02/2024 4:30 pm
Teilen: