Avisos
Vaciar todo

Prusament PETG vs Prusa PETG  

  RSS
towlerg
(@towlerg)
Noble Member
Prusament PETG vs Prusa PETG

I realize these filaments are made by different manufactures to a different "receipt" and that Prusaslicer has slightly different profiles. Has any one tried both and found (as I did) that it's much easier to get the Prusament to adhere?

Respondido : 09/02/2021 5:06 pm
cwbullet
(@cwbullet)
Miembro
RE: Prusament PETG vs Prusa PETG

Prusa is Filament Pm - I think.  I have found that Prusament works well for both.  

--------------------
Chuck H
3D Printer Review Blog

Respondido : 10/02/2021 4:21 am
towlerg
(@towlerg)
Noble Member
Topic starter answered:
RE: Prusament PETG vs Prusa PETG
Posted by: @cwbullet

Prusa is Filament Pm - I think.  I have found that Prusament works well for both.  

Sorry, I must be having a senior moment, I don't understand.

Respondido : 10/02/2021 9:37 am
cwbullet
(@cwbullet)
Miembro
RE: Prusament PETG vs Prusa PETG

@towlerg

The old Prusa PETG was made by Filament PM (I think).  Both the Prusa PETG and Prusament PETG settings with for either filament when I tested them.  

--------------------
Chuck H
3D Printer Review Blog

Respondido : 10/02/2021 10:27 am
towlerg
(@towlerg)
Noble Member
Topic starter answered:
RE: Prusament PETG vs Prusa PETG

@cwbullet

Sorry for flogging this to death but did you find any difference between them in their ability to stick to the bed?

Respondido : 11/02/2021 11:03 am
cwbullet
(@cwbullet)
Miembro
RE: Prusament PETG vs Prusa PETG

@towlerg

Only the Galaxy Black for me.  The rest stick fine with either setting.  My PETG plates are well worn and if anything, things stick too much.  

--------------------
Chuck H
3D Printer Review Blog

Respondido : 11/02/2021 11:28 am
towlerg
(@towlerg)
Noble Member
Topic starter answered:
RE: Prusament PETG vs Prusa PETG

Oh dear, I must be having a super dim week. Are you saying that both product stick well or that all except Galaxy Black stick well or you only use Galaxy Black?

Respondido : 12/02/2021 11:02 am
Compartir: