Notifications
Clear all
Strona 2 / 2
Wstecz
RE: Prusament PETG Orange for PPE
I usually dry PLA, PETg, and ABS filaments at 120F (~49C) in the air fryer.
I would not want to try anything even approaching 212F/100C.
If I'm in a hurry, or just want to be sure it's really dry, I'll do 4-6 hours. If I have time I'll let it go overnight for 12 hours.
It's always restored the performance of the filament except in one case where there were multiple hairline cracks, a tightly-wound partial spool that accidentally was left open to room air for over a year. Look closely at the photo below.
Opublikowany : 19/04/2022 11:46 pm
Strona 2 / 2
Wstecz