Notifications
Clear all
Printer enclosure
Napsal : 03/06/2019 3:49 am
RE: Printer enclosure
Pic didn't work
My notes and disclaimers on 3D printing
and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan
Napsal : 03/06/2019 3:53 am
Topic starter
answered:
RE: Printer enclosure
Napsal : 03/06/2019 4:01 am
RE: Printer enclosure
Keep an eye out for temps if you're printing PLA. You need to allow air circulation to avoid the PLA softening and jamming on you.
My notes and disclaimers on 3D printing
and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan
Napsal : 03/06/2019 4:35 am
Topic starter
answered:
RE: Printer enclosure
Thanks for the advice.I have fitted 2 DC circulating fans to keep the air moving and have done approximately 200 hours printing with no issues.
i have found i have very consistantly good results with the enclosure at 24 degrees celsius
Napsal : 03/06/2019 7:00 pm