RE: Printables.com Support and Forum
Many of the models on printables consist of a handful of parts. Some of my models such as the Apollo LUT consist of over 5,600 parts. It is a challenge to organize so many parts. After adding hundreds of parts to one printables model the printables model broke and I was no longer able to update it so I created a new model and decided to break the model up into manageable sections. This one model consists of 32 separate printables models. I am working on the space shuttle launcher and that will break out into about 18 models. If I continue the project and add the FSS and RSS we are talking about probably 6,000 to 7,000 parts another 20 models or so. That is why it would be nice to group the printables models into one single model group.
RE:
You cannot just create collections of models from other users. You can create collections of your own models. And those can be seen by other users as your collections as a group.
RE: Printables.com Support and Forum
That makes sense, thanks.
RE:
Printables just stopped allowing me to change a model from Draft to PUBLISHED. Another user started a post in another forum with same issue. I've published 40 models, so my workflow is not an issue. I even tried a very basic model.. 1 STL, 1 pic.. all mandatory settings. Draft saves fine.. pressing PUBLISH button and PUBLISH NOW shows a published page (without the DRAFT banner), but when refreshing my models, shows the draft site.. Really frustrating that Printables does not have a proper support mechanism. I just can't imagine how Prusa would create this huge channel and not allow users any mechanism to interact with some type of support.