Notifications
Clear all
print fail
So I've been trying to print 3d business cards, but for some reason, this corner usually messes up. Any ideas?
Attachment removed
Napsal : 30/09/2019 10:46 pm
RE: print fail
Too close to the bed. Live Z is too negative?
--------------------
Chuck H
3D Printer Review Blog
Napsal : 30/09/2019 11:55 pm
RE: print fail
Another couple ideas:
- Finger-grease in that area?
- Only using the 3x3 mesh level instead of the 7x7 mesh level?
See my (limited) designs on:
Printables - https://www.printables.com/@Sembazuru
Thingiverse - https://www.thingiverse.com/Sembazuru/designs
Napsal : 01/10/2019 2:50 am
RE: print fail
What ever is smeared all over the bed is not helping; and it looks like the entire front of the bed is lifting.
Napsal : 01/10/2019 3:27 am
RE: print fail
Start by giving your build plate a good scrub with Dawn and copious amounts of water.
The run a Live Z check.
Napsal : 01/10/2019 2:48 pm