Notifiche
Cancella tutti
Power failures and Power off button?
is it normal for MK3S to see a power shut off from the switch on the PSU as a power failure?
every time i unload filament and let the temp drop close to room temp and then i turn OFF my printer then ON and look at the fail status it shows 1 more power failure. i am assuming this is normal behavior.
Postato : 06/09/2019 10:31 pm
RE: Power failures and Power off button?
depends on power supply model and firmware revision
Postato : 06/09/2019 10:35 pm
Topic starter
answered:
RE: Power failures and Power off button?
depends on power supply model and firmware revision
i have the black psu, pmz-24v240wdal and the LCD says firmware 3.7.2-2363
Postato : 06/09/2019 10:43 pm
RE: Power failures and Power off button?
update to the just released 2.8.0 - it gets rid for the power off BEEP
Postato : 06/09/2019 11:16 pm