Notifications
Clear all
Polysmooth settings/ print issues
I have been printing with polysmooth lately and have been trying to figure out good setting. i constantly have support structures falling over and horizontal surfaces printed on top of them are constantly messy. attached are pictures of my current settings and latest print that had the support structure fall over part way through printing a hand messing up the arm and the fingers on the other arm just straight up didn't print. thanks for the help!
Publié : 08/06/2019 12:52 am
Topic starter
answered:
RE: Polysmooth settings/ print issues
Update i tried going the other direction for temperature and tried the same print at 225 nozzle temp instead of 210 and it printed much better and no supports failure.
Publié : 08/06/2019 9:59 pm