Overhang checking in PursaSlicer

Poslední Příspěvek

RSS

prusanewuser

(@prusanewuser)

Prominent Member

Hi, in this program, is there a function to check the overhang angle of my models to see if any part exceeds 45 degrees?

Napsal : 17/06/2020 7:57 pm

Fórum Statistiky

585 Fóra

68.2 K Témata

477.7 K Příspěvky

10 Online

75.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed