has anyone tried Elegoo filament pla or pla+

Dernier message

RSS

salazar

(@salazar)

Eminent Member

has anyone tried Elegoo filament pla or pla+

Has anyone tried Elegoo filament pla or pla+? This filament is among the cheapest I have seen around 13.99 per kilo or 108 per 10 kg. Has anyone used it?

Publié : 26/02/2024 8:24 pm

hkruse

(@hkruse)

Active Member

RE: has anyone tried Elegoo filament pla or pla+

I have printed about 1.5 kg of Elegoo Marble PLA. No problems using "Generic PLA" settings, but I only used it for decorative items, so I can't comment on strength etc. The only unusual thing I noticed is that at least their marble PLA seems quite a bit more translucent than most other PLAs.

Publié : 26/02/2024 8:48 pm

Statistiques du forum

566 Forums

63.2 K Sujets

444.2 K Messages

22 En-ligne

68.1 K Membres

Le dernier des messages: Filament stuck in nextruder Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé