Notifiche
Cancella tutti
First Layer Ripple/Wave
Hello Community,
Am fairly new to 3d printing. My first layer is coming with a ripple/groove across the lines. It's smooth to touch but I find it visually unpleasant. This is coming both with smooth PEI and textured PEI sheets on my MINI+. What could I do to avoid this?
Postato : 08/09/2022 11:45 am
MODERATORS: can you move this to the appropriate forum?
@eyes: Your first layer Z is calibrated a fraction too low, it is very close so change it in baby steps until this resolves.
Cheerio,
Postato : 08/09/2022 5:26 pm