Filament spool too wide
I have a new spool of Prusament but it won't fit into my AMS or my dry boxes because the spool itself is ever so slightly too wide.
All my other Prusament spools have been fine - its just this one which seems it wasn't pushed together properly from factory.
Of course I can't push it together any further now because it's wound with a full spool of filament.
Is there anything else I can do other than manually wind the entire 1kg of filament onto another spool, which would not only take ages, but is super tedious!
I know there are mechanisms and spool winders I could print, but I'd rather not print an entire solution for a single spool.......
Ideas?
RE: Filament spool too wide
Maybe find someone locally and offer a spool swap? 😀
See my GitHub and printables.com for some 3d stuff that you may like.