Notifications
Clear all

Bridges and or overhangs.  

  RSS
John Lindo
(@john-lindo)
Eminent Member
Bridges and or overhangs.

Can this bridging and overhang terminology be explained further.

The way I see it and me being a non engineering expert " overhang is when a portion of a vertical wall  juts out, a bridge normally connects 2 portions 

of overhangs.

Unfortunately "gravity" gets in the way of extended overhangs and bridges were built with appropriate arcs come to the rescue and even allowing

a pathway to cross.

I recently watched a you tube video showing revised settings of the Prusa slicer 2.6 and getting totally confused with recommended speed settings.

Could the recommended speed settings for overhangs be calculated using a spread sheet ? distance of overhang versus versus the

setting of the filament temperature ?

I still think the way to go is using the organic support option.

Thanks

John

Spain

 

 

 

 

 

 

Posted : 28/08/2024 4:18 pm
Share: