Notifications
Clear all
blobs on top layers
I've got some blobs on the top layers of some prints, any ideas? Over extrusion maybe?
Napsal : 19/10/2019 7:01 am
RE: blobs on top layers
Normal; they are wipe marks and stringing from retraction and lifting the nozzle.
ps: on a side note, it looks like you are over-extruding a bit, too. Test the extruder and measure the filament diameter, adjust slice settings accordingly. https://help.prusa3d.com/article/d9j1xdg7vj-extrusion-multiplier-calibration
This post was modified před 5 years 2 times by --
Napsal : 19/10/2019 8:17 am
Topic starter
answered:
RE: blobs on top layers
@tim-m30
Thank you
Napsal : 19/10/2019 8:05 pm