Notifications
Clear all

Better Software than OctoPrint?  

Strona 2 / 2
  RSS
Gordon W
(@gordon-w)
Reputable Member
RE: Better Software than OctoPrint?

If you're looking for Pis https://rpilocator.com/ is a great site.

Opublikowany : 16/07/2022 5:21 pm
Pedroid polubić
HermannSW
(@hermannsw)
Estimable Member
RE: Better Software than OctoPrint?

I am using Pi2B with OcotPi OS without issues.

No heatsinks, since I did not imprison my Pi2B in a case.
It is mounted with both sides air on my OctoPi holder, together with Raspberry v1 scene camera on top:
https://forum.prusa3d.com/forum/user-mods-octoprint-enclosures-nozzles/octopi-holder-for-prusa-mini/#post-585175

Pi2B is limited to 1 USB port which is used to connect with my Prusa MINI+.
I use a 2nd (USB) camera with OctoPrint, and had to use a small USB hub allowing to connect both, MINI+ and camera with the Pi2B.

OctoPrint allows to toggle between scene view and nozzle view camera!
https://forum.prusa3d.com/forum/user-mods-octoprint-enclosures-nozzles/simple-nozzle-camera-borescope-holder-for-prusa-mini/#post-585166

 

Opublikowany : 17/07/2022 9:00 pm
Clemens M.
(@clemens-m)
Noble Member
RE: Better Software than OctoPrint?

 

Posted by: @gordon-w

If you're looking for Pis https://rpilocator.com/ is a great site.

Nice page - only one problem: NO Pi's in STOCK !!! Same as every where.

Best regards, Clemens

Mini, i3 MK2.5S, i3 MK4, CClone (Eigenbau)

Opublikowany : 17/07/2022 9:06 pm
Netpackrat
(@netpackrat)
Reputable Member
RE: Better Software than OctoPrint?

Lots of them on Ebay.

https://www.printables.com/@Netpackrat/models
Opublikowany : 17/07/2022 9:31 pm
Strona 2 / 2
Share: