Hall of Shame  

RE: Hall of Shame

I'm sure everyone has some like these.

RE: Hall of Shame

@baklin

Yup that is a good one.  

RE: Hall of Shame

  th

I simply refer to this as yellow poo.  What you have to have n your diet to get this?

RE: Hall of Shame

The blob is coming to get you!

RE: Hall of Shame

I'm so glad this never happened to me (so far)

RE: Hall of Shame

@baklin

Eventually, it happens to all of us.  

RE: Hall of Shame

Posted by: @cwbullet

  th

I simply refer to this as yellow poo.  What you have to have n your diet to get this?

Attachment removed

That looks like a jellyfish turd!

RE: Hall of Shame

PS I learnt a valuable lesson a few weeks ago.

Don't place narrow rods on the inside of a ring, brims don't work on the inside of a solid ring and will result in a hotend of doom when they detatch from the bed.

My camera helped me notice it and stop before it turned into  a wombat poop of death!!

RE: Hall of Shame

Posted by: @clarmrrsn

Posted by: @cwbullet

  th

I simply refer to this as yellow poo.  What you have to have n your diet to get this?

Attachment removed

That looks like a jellyfish turd!

Maybe it is a Rorschach Test!  You see what you want to see.  

RE: Hall of Shame

@clarmrrsn

Yup.  I rarely have a disaster because I catch them on the camera too, but when I do they are impressive.  

RE: Hall of Shame

Best Q ASA will just not stick!

RE: Hall of Shame

RE: Hall of Shame

@cwbullet

How did you clean this up?

RE: Hall of Shame

I use a soldering iron to pare the Blob away from the wires of the thermistor and heater

and use nozzle heat to heat from the inside

regards Joan

RE: Hall of Shame

@scaldinghotcarl

I have a heat gun.  It all came off with tweezers.  

Spaghetti Monster Ahoy

One of my worst to date. Tried printing Nefertiti overnight shortly after I built my printer. At least it didn't blob all over the hotend 🙂

Goodnone

That is a good one.  

RE: Spaghetti Monster Ahoy

truly a monstrous spaghetti work of art. I hope your printer survived without any damage 👍 

wbr,

Karl

RE: Hall of Shame

I had this fantasy that I could build my MK3 and print a perfect benchy straight away.  In reality, it took me about 11 hours to assemble and I finished at 2am.  Still holding onto the fantasy I fired off the boat and watched the first couple layers go down.  Well, I had a lot to learn about what a good first layer looks like because the print popped off right after I walked away and went to bed.  When I woke up my fantasy had turned to spaghetti.