Hall of Shame
Post you awesome failures in 3D Printing in this thread.
Below is one of mine.
--------------------
Chuck H
3D Printer Review Blog
RE: Hall of Shame
I'm sure everyone has some like these.
RE: Hall of Shame
@baklin
Yup that is a good one.
--------------------
Chuck H
3D Printer Review Blog
RE: Hall of Shame
th
I simply refer to this as yellow poo. What you have to have n your diet to get this?
--------------------
Chuck H
3D Printer Review Blog
RE: Hall of Shame
The blob is coming to get you!
--------------------
Chuck H
3D Printer Review Blog
RE: Hall of Shame
I'm so glad this never happened to me (so far)
RE: Hall of Shame
@baklin
Eventually, it happens to all of us.
--------------------
Chuck H
3D Printer Review Blog
RE: Hall of Shame
PS I learnt a valuable lesson a few weeks ago.
Don't place narrow rods on the inside of a ring, brims don't work on the inside of a solid ring and will result in a hotend of doom when they detatch from the bed.
My camera helped me notice it and stop before it turned into a wombat poop of death!!
Tank you very much!
RE: Hall of Shame
th
I simply refer to this as yellow poo. What you have to have n your diet to get this?
Attachment removedThat looks like a jellyfish turd!
Maybe it is a Rorschach Test! You see what you want to see.
--------------------
Chuck H
3D Printer Review Blog
RE: Hall of Shame
@clarmrrsn
Yup. I rarely have a disaster because I catch them on the camera too, but when I do they are impressive.
--------------------
Chuck H
3D Printer Review Blog
RE: Hall of Shame
Best Q ASA will just not stick!
--------------------
Chuck H
3D Printer Review Blog
RE: Hall of Shame
RE: Hall of Shame
@cwbullet
How did you clean this up?
RE: Hall of Shame
I use a soldering iron to pare the Blob away from the wires of the thermistor and heater
and use nozzle heat to heat from the inside
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: Hall of Shame
@scaldinghotcarl
I have a heat gun. It all came off with tweezers.
--------------------
Chuck H
3D Printer Review Blog
Spaghetti Monster Ahoy
One of my worst to date. Tried printing Nefertiti overnight shortly after I built my printer. At least it didn't blob all over the hotend 🙂
Goodnone
That is a good one.
--------------------
Chuck H
3D Printer Review Blog
RE: Spaghetti Monster Ahoy
truly a monstrous spaghetti work of art. I hope your printer survived without any damage 👍
wbr,
Karl
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: Hall of Shame
I had this fantasy that I could build my MK3 and print a perfect benchy straight away. In reality, it took me about 11 hours to assemble and I finished at 2am. Still holding onto the fantasy I fired off the boat and watched the first couple layers go down. Well, I had a lot to learn about what a good first layer looks like because the print popped off right after I walked away and went to bed. When I woke up my fantasy had turned to spaghetti.