Fractal Pyramid
This pyramid had its eyes on me even before I got the printer. Now I had small amount of silver PLA left on roll so did not want to make anything big from it. It is only 14 grams a piece so that end of the roll has enough PLA to make 5-7 of these.
Gave the pyramid a go.
Than another go and glued two together.
Watching it print almost gave me a headache. First layers were fine, but when the pyramids stacked up on themselves, reversed and stacked up again while wobbling in front of my eyes 
Got the file from here and followed the instruction on Cura settings: http://www.thingiverse.com/thing:1356547 pyramid5. Slic3r had a fit with this model. The bigger version is already sliced and waits its turn until I have a day to over watch this thing printing.
Re: Fractal Pyramid
came out good man
Re: Fractal Pyramid
Awesome quality print.