Another bad hair day print  

RE: Another bad hair day print

uh oh!

RE: Another bad hair day print

Second print same results:

RE: Another bad hair day print

I am going to have to use some hair spray to tame that bugger.  

RE: Another bad hair day print

What is it that you are trying to print?

RE: Another bad hair day print

@jsw

I am trying to print an Avionics bay for a rocket. It is sort of a cylinder sliced in two length size.  It has a 38mm circle at each end.  It should stick well.  Darn ABS-T is not sticking at all.  

RE: Another bad hair day print

Bummer, dont you just hate it when you start a print and end up with wire wool.

RE: Another bad hair day print

@clarmrrsn

Yup.  It will melt in acetone and be useful for other purposes.  

RE: Another bad hair day print

Two times is  suspicious   I had a huge blob of death because I had errant model with a small projecting part on what should have been the bottom layer. 

RE: Another bad hair day print

@john-6

I would agree, but I have successfully printed this one before.  I think my PEI sheet is worn out.  

RE: Another bad hair day print

your Getting good at these, but I liked the blue one the best. 😉 

RE: Another bad hair day print

@swiss_cheese

Yup.  That would be granny hair.  

RE: Another bad hair day print

I am printing rocket motor retainers which have a ring.  I keep trying to print them without a brim.  I might have to add one.