ERR: 10.0.0.** when uploading gcode to Prusa Link via Connect

Dernier message

RSS

Kraken Reef

(@kraken-reef)

New Member

ERR: 10.0.0.** when uploading gcode to Prusa Link via Connect

Gotten this code on multiple printers when uploading to Prusa Link via Prusa Connect. Uploading via Prusa Link directly works fine. Very small files work fine. Uploading to Prusa Connect, then transfering to printer results in same error on the printer. Tried with multiple g-code files, and results are repeatable, with some able to upload without error. All flashed with current firmware and current image on Pi Zero 2W.

Publié : 07/12/2022 3:25 am

Tojik

(@tojik)

Membre Moderator

RE: ERR: 10.0.0.** when uploading gcode to Prusa Link via Connect

I think this is being fixed right now. Sou hopefully it's fixed soon.

Publié : 07/12/2022 5:09 pm

Statistiques du forum

559 Forums

63 K Sujets

443.2 K Messages

19 En-ligne

67.8 K Membres

Le dernier des messages: immer öfter Fehler bzw fehlende Z-Line Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé