Buddy 3D stuck on firmware 3.0.1
 
Notifications
Clear all

Buddy 3D stuck on firmware 3.0.1  

  RSS
unregistered
(@unregistered)
Active Member
Buddy 3D stuck on firmware 3.0.1

How do I get it to upgrade to 3.0.4?

Posted : 05/06/2025 1:29 pm
lambert
(@lambert-2)
Eminent Member
RE: Buddy 3D stuck on firmware 3.0.1

https://forum.prusa3d.com/forum/buddy3d/buddy3d-camera-update/#post-745646

Posted : 05/06/2025 8:28 pm
unregistered
(@unregistered)
Active Member
Topic starter answered:
RE:

 

Posted by: @lambert-2

https://forum.prusa3d.com/forum/buddy3d/buddy3d-camera-update/#post-745646

I can't seem to access that link plus the link in that thread does not seem to come from an official prusa source, how do I know if it's genuine and not dangerous?

 

Is there an official prusa link for the firmware?

This post was modified 3 months ago by unregistered
Posted : 06/06/2025 3:13 am
lambert
(@lambert-2)
Eminent Member
RE: Buddy 3D stuck on firmware 3.0.1

Hello, your are Right. 
I have no clue about the original Firmware. 
but this worden for me. There is a forumtopic about this update. Maybe you should ask there or contact The prusa Support.

greetings Chris 

Posted : 07/06/2025 9:04 pm
k1mu
 k1mu
(@k1mu)
Trusted Member
RE: Buddy 3D stuck on firmware 3.0.1

https://connect-ota.prusa3d.com/ gets a pointer to https://connect-ota.prusa3d.com/file/cam-3.0.1.tar

The obvious change to "cam-3.0.4.tar" gets me a "File not found".

(Yes, I've been trying to reverse-engineer the camera.)

Posted : 13/06/2025 10:34 pm
Share: