What is causing this in the letters of my logo?
Info First:
Kit MK3S+/Kit PLA Grey
215 First layer/210 rest/60 bed/preheat
-1.495 Z/7x7 bed level check
Hi everyone! I was hoping to find out what is causing this pooling/globbing in the letters of the Prusa logo? The first layer looks wonderful...I think.
My guess is heat related? No idea though. Thanks!
Best Answer by sylviatrilling:
Your z-offset might be too high. Try the calibration at the following link. https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/life-adjust-z-my-way/
Z-offset
Your z-offset might be too high. Try the calibration at the following link. https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/life-adjust-z-my-way/
Mk3S+,SL1S
Further investigation!
Hi thank you for the quick reply. I realized I've posted in the wrong forum for my MK3S. Sorry about that!
Anyway, I will move on to the square for further calibration. Had been only using the built in zipper with the mini square at the end. Thanks again for the advice!
Your z-offset might be too high. Try the calibration at the following link. https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/life-adjust-z-my-way/