Notifications
Clear all
Stuck in - First steps, section Calibration flow. Printer has not been calibrated yet...
Ran the self test an my original error message said that my Heatbed Thermistor wasn't connected. I checked and it was. Saw on the forum that there was a firmware update that may fix that problem. Downloaded and did the flash thing. Now it's stuck in the spot where I mentioned. Help! Cant figure out what stupid mistake I made.
Publié : 24/07/2021 2:54 am
reply
Can't remember there was a firmware update related to this error (maybe it was way back).
Anyway, error message is quite obvious and to be sure, you should measure with multimeter (only visual inspection can sometimes fool us).
[Mini+] [MK3S+BEAR]
Publié : 24/07/2021 7:08 am
Topic starter
answered:
reply
Thanks! Sorry for the late reply. I got it going. Can't even remember what the issue was. smh
Publié : 24/09/2021 8:50 pm