Notifications
Clear all
Poor Adhesion Tips on first layer
Hi all,
Been doing a few prints and started to notice some parts of my first layer warp a little bit, the next layers are fine, it's just the first layer that is problematic. PETG, Prusa Mini, standard steel sheet that comes with it. My first layer test always comes out perfect. Example below:
Opublikowany : 21/01/2023 2:23 am
It looks like you have fingerprints on your print-sheet. Time for a thorough clean.
Cheerio,
Opublikowany : 21/01/2023 5:48 pm
RE: Poor Adhesion Tips on first layer
Joan always provides helpful tips::
https://forum.prusa3d.com/forum/postid/633681/
wbr,
Karl
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
Opublikowany : 21/01/2023 6:05 pm