Mini+ reverse elephants foot???  

RE: Mini+ reverse elephants foot???

Forgot to note: I'm using the stock Prusament PETG profile (except when checked "External Perimeters Firsts") at .15 layer height. 

RE: Mini+ reverse elephants foot???

I am still fairly new to 3d printing, the Mini+ is my first printer.

First off, me too.

Recently, my prints started bulging out on the top layers and I can't figure out what is going on. I tried printing the Fidget Clicking Wheel 2.0 https://www.printables.com/model/231691-fidget-clicking-wheel-20 and as you can see, the top layers are sticking out further than the bottom layers. I even tried to modify the stl to add a chamfer to the top and bottom. But that had no effect. The only mods I have done to my Mini+ is the Bondtech extruder (not the heat-break). Has anyone else seen this? or hopefully know how to fix it?

This didn't happen after you installed the Bontech extruder, did it?

One thing I'm noticing (and again I'm not an expert) is that the lower layers are not sticking out as far as the layers above them. You said you re-did the 1st layer calibration. What does the first layer look like?

RE: Mini+ reverse elephants foot???

I honestly don't know for sure if it was happening before. I would only print objects that didn't need to be accurate. Like frogs and other useless things. I changed to the Bondtech extruder because I hated how the factory tension worked. It wasn't until recently that I started printing objects that required higher accuracy. Like gears, that's when I started to notice the issue.

RE: Mini+ reverse elephants foot???

Weird. Yeah I'd say your first layer calibration looks great. I think I will try to print this gear later and see how my printer does.

I changed to the Bondtech extruder because I hated how the factory tension worked.

I see a lot of comments regarding the Prusa extruder tensioner, like your comment, or people talking about constantly adjusting the screw. I set my screw, and haven't touched it since. Maybe I got lucky?

RE: Mini+ reverse elephants foot???

Weird. Yeah I'd say your first layer calibration looks great. I think I will try to print this gear later and see how my printer does.

I would definitely appreciate you trying to print it, just to see. I scaled it bigger and smaller, but it didn't seem to make a difference. 

I see a lot of comments regarding the Prusa extruder tensioner, like your comment, or people talking about constantly adjusting the screw. I set my screw, and haven't touched it since. Maybe I got lucky?

It started clicking pretty loud for some reason too and sometimes it would be hard to feed the filament into it. I'm sure I just needed to clean and readjust it but opted for the Bondtech. It's definitely higher quality than the factory one, I really like it. 

RE: Mini+ reverse elephants foot???

So I had some different gears, for a model transmission, that I had printed in PLA this weekend. I took a close look and sure enough, the tops stick out slightly. Weird…

I’ll try to get pictures later.