Benachrichtigungen
Alles löschen
Lumpy layer
Hi there
I'm having trouble with my print 'lifting'. I have tried various temperatures from 200 to 220, but I still get it. The strange thing is, it is not every time. I always clean the print plate
Any ideas?
Dieses Thema wurde geändert Vor 2 years von Avondale
Veröffentlicht : 14/05/2023 6:54 am
Is it commoner on prints with a large footprint?
I suspect your first layer Z calibration is set a fraction too low; you are very close though so baby step the calibration.
Cheerio,
Veröffentlicht : 14/05/2023 4:51 pm