Click while printing.
Hi, I just set up a brand new Prusa Mini+ (installed the latest firmware) and I'm getting a clicking sound on fast moments, perimeters are silent. It's hard to tell if it's coming from the X or Y stepper motors.. The file that I'm printing is from the included USB. I also sliced a part and slowed down retraction, that didn't help. It's not affecting print, just the clicking which is louder than my Creality CR10-v3 which is crazy load.
Any ideas?
Thanks,
Randy
Video
A short video of the first layer calibration might help.
--------------------
Chuck H
3D Printer Review Blog
Extruder gear when retracting?
Hi
There is a recent post talking about "clicking" don't know if it's the same...
https://forum.prusa3d.com/forum/hardware-firmware-and-software-help/mini-clicking-but-good-prints/
Keep us posted
JC
Prusa MINI+ at home / Prusa MK3S+ in the Fab Lab / You can have a look at my designs here printables.com