Bed issues?
Hi,
i noticed that i have some issues when printing huge objects so i used the OctoPi Bed Visualizer and this result came out:
Recv: 0 -0.155 +0.048 +0.072 -0.044
Recv: 1 -0.017 +0.204 +0.184 +0.118
Recv: 2 -0.022 +0.163 +0.192 +0.175
Recv: 3 -0.195 +0.052 +0.168 +0.160
I did the measurements with a SPINDA.
This looks for me like extremely uneven. Is there somethin i can do about it? Is that normal?
RE: Bed issues?
Hi,
i noticed that i have some issues when printing huge objects so i used the OctoPi Bed Visualizer and this result came out:
Recv: 0 -0.155 +0.048 +0.072 -0.044
Recv: 1 -0.017 +0.204 +0.184 +0.118
Recv: 2 -0.022 +0.163 +0.192 +0.175
Recv: 3 -0.195 +0.052 +0.168 +0.160
I did the measurements with a SPINDA.
This looks for me like extremely uneven. Is there somethin i can do about it? Is that normal?
Maybe your printing bed is not completely flat. check it with a ruler.
To compensate for this, you could install the silicon-, nylock- or spring mod.
https://www.reddit.com/r/prusa3d/comments/bp440f/full_guide_to_doing_nylock_mod_if_you_havent_you/ (also possible for the Mini).
https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-improvements-archive/bed-levelling-mod-bed-level-calibration-guide-for-beginners-also/ (also possible for the Mini).
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.