Français
Forums
Membres
zukpr
Activité
 
Notifications
Clear all
zukpr
zukpr
Groupe: Enregistré
A(ont) rejoint: 2022/08/09
Eminent Member
2
Profil Activité
I've had exactly the same problem and posted about it a whil...

Dans le forum Hardware, firmware and software help

 il y a 2 years
Thanks for the reply. That helps. I did hot-tighten the nozz...

Dans le forum Hardware, firmware and software help

 il y a 2 years
Leakage after nozzle change - help requested, questions at t...

Dans le forum Hardware, firmware and software help

 il y a 2 years
As I noted above, I changed the PTFE tube. But I had the sa...

Dans le forum Hardware, firmware and software help

 il y a 2 years
I decided to change the PTFE tube. The one I removed was sl...

Dans le forum Hardware, firmware and software help

 il y a 2 years
Having trouble unloading filament

Dans le forum Hardware, firmware and software help

 il y a 2 years
My understanding is that as you lower the temperature you ev...

Dans le forum How do I print this? (Printing help)

 il y a 2 years
My story is similar to yours. I'm new to 3D printing. I go...

Dans le forum Assembly and first prints troubleshooting

 il y a 2 years
Thanks for the advice and the offer to look at the file. I ...

Dans le forum How do I print this? (Printing help)

 il y a 2 years
First layer problem - can I fixe this in the slicer?

Dans le forum How do I print this? (Printing help)

 il y a 2 years
I got a sunlu dryer and dried the filament for six hours (sa...

Dans le forum Assembly and first prints troubleshooting

 il y a 2 years
Thanks for the reply. Now that I'm thinking about it, I did...

Dans le forum Assembly and first prints troubleshooting

 il y a 2 years
Is this stringing worth trying to reduce?

Dans le forum Assembly and first prints troubleshooting

 il y a 2 years
Page 2 / 2
Partager :