Čeština
Fóra
Uživatelé
zukpr
Aktivita
 
Notifications
Clear all
zukpr
zukpr
Skupina: Registrovaný
Přidal se: 2022/08/09
Eminent Member
2
Profile Aktivita
I've had exactly the same problem and posted about it a whil...

In forum Hardware, firmware and software help

 před 3 years
Thanks for the reply. That helps. I did hot-tighten the nozz...

In forum Hardware, firmware and software help

 před 3 years
Leakage after nozzle change - help requested, questions at t...

In forum Hardware, firmware and software help

 před 3 years
As I noted above, I changed the PTFE tube. But I had the sa...

In forum Hardware, firmware and software help

 před 3 years
I decided to change the PTFE tube. The one I removed was sl...

In forum Hardware, firmware and software help

 před 3 years
Having trouble unloading filament

In forum Hardware, firmware and software help

 před 3 years
My understanding is that as you lower the temperature you ev...

In forum How do I print this? (Printing help)

 před 3 years
My story is similar to yours. I'm new to 3D printing. I go...

In forum Assembly and first prints troubleshooting

 před 3 years
Thanks for the advice and the offer to look at the file. I ...

In forum How do I print this? (Printing help)

 před 3 years
First layer problem - can I fixe this in the slicer?

In forum How do I print this? (Printing help)

 před 3 years
I got a sunlu dryer and dried the filament for six hours (sa...

In forum Assembly and first prints troubleshooting

 před 3 years
Thanks for the reply. Now that I'm thinking about it, I did...

In forum Assembly and first prints troubleshooting

 před 3 years
Is this stringing worth trying to reduce?

In forum Assembly and first prints troubleshooting

 před 3 years
Stránka 2 / 2
Share: