Prusa3D Forum

Notifications

Clear all

zim2dive

Groupe: Enregistré

A(ont) rejoint: 2023/02/20

Active Member

	Frozen x-axis... grub(?) /set screw fell out Dans le forum Hardware, firmware and software help	il y a 4 months
	well @%#$^# ... thanks for the heads-up... wow... for re... Dans le forum General discussion, announcements and releases	il y a 4 months
	cheapish enclosure if you don't want to DIY Dans le forum General discussion, announcements and releases	il y a 4 months
	My prints seem fine (best in a while after some x-axis adj) ... Dans le forum Hardware, firmware and software help	il y a 4 months
	yeah, I looked at that.. but I didn't have any Prusa PETG ha... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I used the X-belt as a comparison and there was a noticeable... Dans le forum How do I print this? (Printing help)	il y a 2 years
	hmm, almost worse 🙂 I printed 4 copies and they were all l... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Strategy for printing small/fine items? (can I?) Dans le forum How do I print this? (Printing help)	il y a 2 years
	Just piling on 🙂 Same issue. The upload works, but the pr... Dans le forum Hardware, firmware and software help	il y a 3 years

Statistiques du forum

585 Forums

68 K Sujets

476.6 K Messages

12 En-ligne

75.6 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé