Notifications
Clear all
Your Fave Mullet
Group: Registered
Joined: 2021/06/21
Active Member
1
| This problem existed before changing the bearings, hence why... | 3 months ago | |
| I know of this but I was hoping to remedy the cause of the i... | 3 months ago | |
| Hi Diem, thank you for your reply. The nozzle used for the p... | 3 months ago | |
| First Layer Gaps At Certain Points of Bed | 3 months ago | |
| X/Y Axis Slightly Skewed After XYZ Recal | 2 years ago | |
|
Lines on print? In forum Hardware, firmware and software help |
3 years ago | |
| Fantastic stuff from both there. Wow this is all amazing adv... | 3 years ago | |
| Hi all! Great news! Benchy was a success!! So there are a co... | 3 years ago | |
| @diem Ahhh I see! So the device is to be "worn" in so to spe... | 3 years ago | |
| @john-6 This is great stuff thank you!! | 3 years ago | |
| @brad-3 Ah thank you so much! I'll lower it a little. At the... | 3 years ago | |
| @john-6 Hi John Thanks for your reply 🙂 I agree they ain't b... | 3 years ago | |
| Problem - Benchy overhang curl hitting nozzle | 3 years ago |