Prusa3D Forum

Notifications

Clear all

yophosis

Groupe: Enregistré

A(ont) rejoint: 2019/11/22

Active Member

	Thank you for the replies. I will go to the hardware store w... Dans le forum Hardware, firmware and software help	il y a 4 years
	Ok, I will focus on one question: How do you get these set s... Dans le forum Hardware, firmware and software help	il y a 4 years
	I should include more information; the first time I replaced... Dans le forum Hardware, firmware and software help	il y a 4 years
	Heat Block loose? Heat break set-screws really 1.5mm? Dans le forum Hardware, firmware and software help	il y a 4 years
	This is really easy to do once you get the hang of it, open ... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	The smooth PEI steel sheet grabs the filament much better fo... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Had this problem. Before I click "load filament" I open the... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	@whmacintosh I have a theory that the USB sticks are overhea... Dans le forum Hardware, firmware and software help	il y a 5 years
	Smaller print jobs print just fine with the supplied prusa U... Dans le forum Hardware, firmware and software help	il y a 5 years
	This just happened to me 10 hours in on a print. I used Slic... Dans le forum Hardware, firmware and software help	il y a 5 years

Statistiques du forum

565 Forums

63.6 K Sujets

446.1 K Messages

24 En-ligne

68.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé