Notifications
Clear all
yetanotheraccount
yetanotheraccount
Groupe: Enregistré
A(ont) rejoint: 2020/06/27
Active Member
1
Okay. Per your email, if the IR thing is broken it will con...

Dans le forum General discussion, announcements and releases

il y a 4 years
I have reset this thing multiple times. The xyz calibration...

Dans le forum General discussion, announcements and releases

il y a 4 years
@kenny-2 no. i have not fixed it.

Dans le forum General discussion, announcements and releases

il y a 4 years
I did xyz to see if it would help. I was using 2.2.0 of the ...

Dans le forum General discussion, announcements and releases

il y a 4 years
I have the exact same problem. I updated the firmware to 3....

Dans le forum Hardware, firmware and software help

il y a 4 years
The print head does not move when printing.

Dans le forum General discussion, announcements and releases

il y a 4 years
How do I move the "extruder head" on the MMU2S?

Dans le forum General discussion, announcements and releases

il y a 4 years
???? are you saying that what i'm asking for is impossible?

Dans le forum General discussion, announcements and releases

il y a 4 years
I see no reason why I have to have a .stl or any other file ...

Dans le forum General discussion, announcements and releases

il y a 4 years
My original question was about how to permanently assign the...

Dans le forum General discussion, announcements and releases

il y a 4 years
Where is that supposed to be set? In the configuration wiza...

Dans le forum General discussion, announcements and releases

il y a 4 years
bewildered by the slicer

Dans le forum General discussion, announcements and releases

il y a 4 years
pslicer on pi 3

Dans le forum PrusaSlicer

il y a 4 years
(splutter!) well, whatever happened, that's what I thought ...

Dans le forum General discussion, announcements and releases

il y a 4 years
downloadable 3d parts

Dans le forum General discussion, announcements and releases

il y a 4 years
Partager :