Avisos
Vaciar todo
yetanotheraccount
yetanotheraccount
Grupo: Registrado
Registrado: 2020/06/27
Active Member
1
Okay. Per your email, if the IR thing is broken it will con...

En el foro General discussion, announcements and releases

hace 4 years
I have reset this thing multiple times. The xyz calibration...

En el foro General discussion, announcements and releases

hace 4 years
@kenny-2 no. i have not fixed it.

En el foro General discussion, announcements and releases

hace 4 years
I did xyz to see if it would help. I was using 2.2.0 of the ...

En el foro General discussion, announcements and releases

hace 4 years
I have the exact same problem. I updated the firmware to 3....

En el foro Hardware, firmware and software help

hace 4 years
The print head does not move when printing.

En el foro General discussion, announcements and releases

hace 4 years
How do I move the "extruder head" on the MMU2S?

En el foro General discussion, announcements and releases

hace 4 years
???? are you saying that what i'm asking for is impossible?

En el foro General discussion, announcements and releases

hace 4 years
I see no reason why I have to have a .stl or any other file ...

En el foro General discussion, announcements and releases

hace 4 years
My original question was about how to permanently assign the...

En el foro General discussion, announcements and releases

hace 4 years
Where is that supposed to be set? In the configuration wiza...

En el foro General discussion, announcements and releases

hace 4 years
bewildered by the slicer

En el foro General discussion, announcements and releases

hace 4 years
pslicer on pi 3

En el foro PrusaSlicer

hace 4 years
(splutter!) well, whatever happened, that's what I thought ...

En el foro General discussion, announcements and releases

hace 4 years
downloadable 3d parts

En el foro General discussion, announcements and releases

hace 4 years
Compartir: