Prusa3D Forum

Notifications

Clear all

XavAcid

Groupe: Enregistré

A(ont) rejoint: 2016/12/20

Active Member

	It happened to me once, because I didn't have it tight enoug... Dans le forum Assembly and first prints troubleshooting	il y a 9 years
	this is mine. Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Ok I went around and tighten some screws that felt loose. An... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Can I just go to the store and tell them I need ato 5 amp fu... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	My pinda is only slightly higher than the nozzle. The light ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	XYZ calibration failed at the 4th point Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I just pulled the F3 fuse, and yes it is blown ( looked from... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I think I've blown a fuse from gripping the heat block too t... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Thank you so much! I'm gonna have to order the ABS. Learni... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	PINDA prob hold just broke Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Ok, I've seemed to solve it now. I did the atomic pull one ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	clogged nozzle? Dans le forum Prusa i3 kit (Archive)	il y a 9 years

Statistiques du forum

585 Forums

68.1 K Sujets

477.2 K Messages

17 En-ligne

75.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé