Prusa3D Forum

Notifications

Clear all

XavAcid

Skupina: Registrovaný

Přidal se: 2016/12/20

Active Member

	It happened to me once, because I didn't have it tight enoug... In forum Assembly and first prints troubleshooting	před 9 years
	this is mine. In forum Prusa i3 kit (Archive)	před 9 years
	Ok I went around and tighten some screws that felt loose. An... In forum Prusa i3 kit (Archive)	před 9 years
	Can I just go to the store and tell them I need ato 5 amp fu... In forum Prusa i3 kit (Archive)	před 9 years
	My pinda is only slightly higher than the nozzle. The light ... In forum Prusa i3 kit (Archive)	před 9 years
	XYZ calibration failed at the 4th point In forum Prusa i3 kit (Archive)	před 9 years
	I just pulled the F3 fuse, and yes it is blown ( looked from... In forum Prusa i3 kit (Archive)	před 9 years
	I think I've blown a fuse from gripping the heat block too t... In forum Prusa i3 kit (Archive)	před 9 years
	Thank you so much! I'm gonna have to order the ABS. Learni... In forum Prusa i3 kit (Archive)	před 9 years
	PINDA prob hold just broke In forum Prusa i3 kit (Archive)	před 9 years
	Ok, I've seemed to solve it now. I did the atomic pull one ... In forum Prusa i3 kit (Archive)	před 9 years
	clogged nozzle? In forum Prusa i3 kit (Archive)	před 9 years

Fórum Statistiky

595 Fóra

69 K Témata

482.3 K Příspěvky

15 Online

77.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed